Key Takeaways
- The ratio here is lean mass divided by fat mass. Lean mass is everything that is not fat, so it is your body fat percent written another way: (100 − body fat %) ÷ body fat %. 80.0 kg at 15% body fat has 68.0 kg lean and 12.0 kg fat, a ratio of 5.67.
- Lean mass is not muscle mass. It also holds bone, organs and water[1]. If a scan report gives you skeletal muscle mass, the optional box adds a second ratio that uses muscle alone.
- Studies have used a muscle-to-fat ratio to flag metabolic syndrome in specific groups, each with its own device, its own muscle measurement and its own cut-offs[2][3]. Those cut-offs do not transfer to this calculator, so it does not label your ratio good or bad.
- It does not give you an InBody C, I or D shape. Those come from comparing three bars on a scan report, and one ratio cannot rebuild them[1].
What the Ratio Is
Split your body weight into two parts: fat mass and everything else. The ratio is the second part divided by the first. A ratio of 4 means 4 kg of lean mass for every 1 kg of fat.
| Quantity | How it is worked out |
|---|---|
| Fat mass | weight × body fat % ÷ 100 |
| Lean mass | weight − fat mass |
| Lean : fat ratio | lean mass ÷ fat mass = (100 − body fat %) ÷ body fat % |
| Skeletal muscle : fat (optional) | skeletal muscle mass ÷ fat mass |
Worked example. 80.0 kg at 15% body fat: fat mass is 80 × 0.15 = 12.0 kg, lean mass is 80 − 12 = 68.0 kg, and the ratio is 68 ÷ 12 = 5.67.
If a scan also reported 36.0 kg of skeletal muscle, that ratio would be 36 ÷ 12 = 3.00.
Because the weight cancels out, the ratio depends only on body fat percent. Two people at 20% body fat both come out at 4.00, whatever they weigh.
So the ratio tells you nothing new about your composition. It is a different way to look at the number you already have, and it makes changes easier to see: going from 25% to 20% body fat moves the ratio from 3.00 to 4.00.
Lean Mass Is Not Muscle Mass
InBody's result-sheet guide defines fat-free mass as the weight of everything except body fat: muscle, water, bones and organs. It defines skeletal muscle mass as the skeletal muscles, the ones that grow with training[1].
The same guide notes that fat-free mass can rise because of swelling from some health conditions, so a higher figure is not always more muscle[1].
That is why the main ratio on this page is called lean mass to fat mass and not muscle to fat. If you call it a muscle-to-fat ratio, you are using lean mass in place of muscle.
The optional skeletal muscle box exists for people who have the real figure from a scan.
Why There Are No C, I or D Shapes Here
InBody's report draws bars for weight, skeletal muscle mass and body fat mass, each measured against an average for your height.
A C shape has a shorter muscle bar than weight and fat bars, an I shape has the three bars roughly in a straight line, and a D shape has a longer muscle bar than the other two[1].
The shape depends on how the three bars compare, and one ratio of lean to fat cannot reproduce that, because it knows nothing about your height or your muscle.
What the Research Says
The muscle-to-fat ratio shows up in the metabolic-syndrome literature, and two papers are worth knowing about. Neither is a reason to read a pass or fail into your number here.
- A Korean study of 6,256 adults from a national health survey tested muscle mass divided by fat mass against metabolic syndrome. The ratio's area under the curve was 0.713 in men and 0.721 in women, and the best cut-offs were 3.09 for men and 1.83 for women[2]. It was a cross-sectional study, so it shows an association at one point in time and not that a low ratio causes anything. The paper reports body composition from DXA scans[2].
- A study of 1,416 young Colombian adults (aged 18 to 25) used bioelectrical impedance and turned the ratio upside down, as fat mass divided by muscle mass. Its best cut-offs were 0.225 for men and 0.495 for women[3]. The group was young, two thirds of it was female, and the device differs from the Korean study's.
Why those cut-offs are not used here
Each cut-off belongs to one device and one population. One study puts muscle on top and the other puts fat on top, and neither states that its muscle figure is the same as the fat-free mass used here.
A lean-to-fat ratio from your body fat percent may not be the same quantity, so holding it against 3.09 or 1.83 could mislead you. If you want a health read on your body composition, a clinician with your full picture is the right place for it.
Getting Your Inputs
You need body weight plus one of body fat percent or fat mass. Scans, smart scales and caliper estimates all give a figure, and different methods can give different numbers.
In one study of 187 adults, skinfold equations read lower than a four-compartment reference by about 3 to 5 percentage points on average for some equations, and the gap depended on how the reference itself was built[5].
So pick one method, use it under the same conditions each time, and compare your own results over time rather than against someone else's.
No scan handy? You can estimate body fat from four skinfolds with the Jackson-Pollock 4-site calculator, then bring the percent back here. To log tape measurements over time, see the body measurements tracker.
What the Number Can and Cannot Tell You
- The ACE bands in the result are fitness-industry norms, not diagnoses[4]. A health-based approach has been proposed that ties body fat ranges to BMI cut-offs, but its authors called the ranges provisional and noted that no accepted body fat ranges existed[6].
- A higher ratio means less fat for the same weight. It does not by itself mean more muscle, better fitness or better health.
- The result is only as accurate as the body fat figure you type in. A few points of error in body fat shifts the ratio noticeably at the lean end: 10% is 9.00 and 12% is 7.33.
- The calculator covers 3% to 60% body fat and weights from 30 to 300 kg. It is not built for children.
Frequently Asked Questions
Sources & References
- Result Sheet Interpretation (definitions of fat-free mass and skeletal muscle mass, and the C, I and D shapes of the Muscle-Fat Analysis). InBody. Manufacturer guide
- Validity of muscle-to-fat ratio as a predictor of adult metabolic syndrome. Park J, Kim S. Journal of Physical Therapy Science 28(3):1036-1045 (2016)
- Fat-to-Muscle Ratio: A New Anthropometric Indicator as a Screening Tool for Metabolic Syndrome in Young Colombian People. Ramírez-Vélez R, Correa-Bautista JE, Sanders-Tordecilla A, et al.. Nutrients 10(8):1027 (2018)
- ACE Body Composition Percentage Chart (American Council on Exercise norms; the chart on ACE's own site now redirects, so this is a hosted copy). American Council on Exercise. Copy hosted by TomTom
- The relative accuracy of skinfolds compared to four-compartment estimates of body composition. Nickerson BS, Fedewa MV, Cicone Z, Esco MR. Clinical Nutrition 39(4):1112-1116 (2020)
- Healthy percentage body fat ranges: an approach for developing guidelines based on body mass index. Gallagher D, Heymsfield SB, Heo M, et al.. American Journal of Clinical Nutrition 72(3):694-701 (2000)

Certified Personal Trainer & Sports Nutritionist
NASM-certified fitness and nutrition coach with over 10 years of hands-on experience helping people build strength, lose fat, and live healthier lives. Specializing in gym-based workouts with a strong focus on lifting technique, biomechanics, and practical exercise science. Through FitLifeRegime, sharing the tools, tips, and insights that have worked for hundreds of clients — helping you start your own fitness journey with confidence and clarity.
Learn more about Manish
NASM Certified
Certified Personal Trainer & Sports Nutritionist from the National Academy of Sports Medicine
Disclaimer: This tool is for informational and personal journaling purposes only. Results are estimates based on published formulas and may vary based on individual factors such as genetics, training history, and measurement technique.