Key Takeaways

  • Give it a 2K or a 20-minute result. It estimates the power you could hold for about 60 minutes and, from a 2K, builds five training zones (UT2, UT1, AT, TR, AN) in watts and splits.
  • From a 2K it uses 76% of your 2K watts for the 60-minute figure. That ratio is Kurt Jensen's, from elite Danish World Champions[2]. It is an elite ratio, so your own may be different.
  • From a 20-minute piece it uses 95% of the watts. That is the cycling convention[9], and no rowing study checks it, so the page marks it as a rough guide[3].
  • Zones are bands of your 2K watts. Those percentages circulate through interactive training plan spreadsheets that rowers quote on the Concept2 forum[10][11]. They are not printed in a Concept2 or British Rowing document, so treat them as a convention and not a standard.
  • Critical power is not FTP in rowing. In one study of 14 male rowers it sat 37% above the power they could hold at a steady lactate level[5], so the old "CP × 0.95" shortcut is gone.

Why "FTP" on a Rower Needs Care

FTP, functional threshold power, came from cycling. In its original form it is the highest power a rider can hold in a quasi-steady state for about an hour, estimated as 95% of a 20-minute test[9].

It works for cyclists because that rule has been checked on cyclists. McGrath and colleagues had 19 highly trained riders hold 95% of their 20-minute power for 60 minutes, and 17 of them finished[3].

No study has shown the same thing for rowers. So this page does two things. It gives you a 60-minute power estimate that rests on rowing data, and it keeps the 20-minute rule as an option with a clear label.

The results say "estimated 60-minute power", which is what the number is.

It is a planning aid. It does the arithmetic and does not tell you what you can do on the day. Use a real 60-minute piece, or a heart rate and effort check, to settle it.

How the Numbers Are Calculated

Three steps. Only the first has a published formula. The other two are ratios, and the table says where each comes from.

StepWhat it doesBasis
1. Split to wattswatts = 2.80 / pace3, with pace in seconds per metre. Back the other way, pace is the cube root of (2.80 / watts)The Concept2 Watts Calculator page[1]. A 2:05 split gives 179.2 W there and here
2. 60-minute powerFrom a 2K: watts × 0.76. From a 20-minute piece: watts × 0.950.76 is Jensen's ratio for elite rowers[2]. 0.95 is the cycling convention[9], held for an hour in 17 of 19 cyclists[3]
3. Zones (2K only)Bands of your 2K watts: UT2 45 to 60%, UT1 60 to 70%, AT 70 to 80%, TR 80 to 105%, AN 105 to 115%, each turned back into splits with the same formulaThe percentages quoted from the UK interactive plan on the Concept2 forum[10][11]. No primary Concept2 or British Rowing document prints them, so they are a convention

What each step uses. Source numbers match the sources list.

Worked example: a 7:30 2K, which is a 1:52.5 split

Pace is 112.5 / 500 = 0.225 s per metre. Watts are 2.80 / 0.2253 = 245.8 W.

The 60-minute estimate is 245.8 × 0.76 = 186.8 W, which is a split of 2:03.3 per 500 m.

A 20-minute average of 200 W gives 200 × 0.95 = 190.0 W, a split of 2:02.6.

The Training Zones

Here are the zones for the 7:30 example, then how British Rowing describes the same codes.

Zone% of 2K wattsWattsSplit per 500 m
UT245 to 60111 to 1472:26.8 to 2:13.4
UT160 to 70147 to 1722:13.4 to 2:06.7
AT70 to 80172 to 1972:06.7 to 2:01.2
TR80 to 105197 to 2582:01.2 to 1:50.7
AN105 to 115258 to 2831:50.7 to 1:47.4

Zones for a 2K average of 245.8 W (1:52.5 per 500 m). Calculated from a convention, not measured.

Watts are used for the bands because power rises with the cube of speed. A band set as a percentage of your split would not mean much. The bands touch, so the top of one zone is the bottom of the next.

Coaches draw these lines a little differently. One forum user comparing the plan's spreadsheet with its written pace table reports that most zones in the table sit about 5% higher in power[11].

That claim is unchecked, which is another reason to treat the bands as a starting point. British Rowing's training matrix describes the same codes by heart rate, blood lactate, effort and stroke rate instead[7].

The values below are as printed in that matrix. Heart rate is given as a percentage of heart rate reserve plus resting heart rate, and effort is on the Foster 0 to 10 scale.

ZoneHeart rateLactate (mmol/l)Effort (0 to 10)Stroke rate
UT259 to 67%under 2.02 to 318 to 19
UT167 to 75%2.0 to 4.0419 to 23
AT75 to 85%about 4.05 to 624 to 28
TR85 to 100%about 4.0 to 8.07 to 828 to 36

British Rowing training matrix, as printed. Source numbers match the sources list.

The matrix is a different system from the watts bands above, and the two will not line up row for row. If your watts zone and your heart rate disagree, believe the one that fits how the session feels and adjust.

What the Research Says

Source numbers match the sources list.

Jensen's ratios. Kurt Jensen compared erg results over several distances for a group of Danish World Champions, with everything set against the 2000 m average watts[2]. Average watts for 60 minutes were around 76% of the 2000 m figure and about 85% over 6000 m.

For 60 seconds and 10 seconds they were 153% and 173%. He reports the ratios were nearly identical for men, women, heavyweights and lightweights, and that data from Italy and the US gave more or less the same percentages for on-water World Champions.

This is the only source for a 60-minute to 2K ratio, and it describes elite rowers. It comes from an interview published by World Rowing and not from a peer-reviewed paper, so 76% is a reasonable starting point and not a rule.

The 20-minute rule in cyclists. McGrath and colleagues tested 19 highly trained cyclists on a Wattbike[3]. Taking 5% off the 20-minute average, 17 of 19 held that power for 60 minutes.

The two who stopped did so at 35 and 52 minutes, and 5% more power pushed lactate and oxygen use out of a steady state. Repeat tests agreed within +13 and -17 W.

That is a good result for cyclists. It is not a rowing study.

Inglis and colleagues compared the same 20-minute rule with the maximal lactate steady state in 18 cyclists[4]. Steady-state power was 93.1% of the 95% figure, on average, with wide spread between people, and the authors did not advise using the rule to stand in for it.

So even in cycling, "FTP" and lactate steady state are different things.

Critical power in rowers. Possamai and colleagues tested 14 male rowers on an erg[5]. Critical power, worked out from 500, 1000, 2000 and 6000 m efforts, averaged 257 W. The power at maximal lactate steady state averaged 187 W.

That is a 37% gap, much bigger than the roughly 10% usually seen in running and cycling. An earlier abstract by Lin and colleagues found 15 elite female rowers could hold critical power for 20 minutes, but their lactate, heart rate and breathing did not settle[6].

For rowing, then, CP × 0.95 does not give a steady-state power, and this page does not offer it.

6K and lactate steady state. In 23 female collegiate rowers, power at maximal lactate steady state was about 78.5% of their 6 km average power, and the two were closely related (r = 0.92)[8].

It is a conference abstract and a small group, so I am quoting it for context and not using it in the calculator.

What This Calculator Cannot Tell You

  • What you can hold for 60 minutes. The result comes from a ratio. A real 60-minute piece, or a steady one at the estimated split with heart rate and effort checked, is the only way to know.
  • Whether the ratio fits you. The 76% comes from elite rowers. Aerobic base, training age and event background all move it, and the sources do not say by how much.
  • A lactate steady state. A best 60-minute effort and the highest steady lactate level are not the same thing. The rowing studies above put steady-state power well below the powers from short tests[5][8].
  • A grade for your fitness. There are no "elite" or "advanced" labels, because no published source sets them. The W/kg figure is just a number you can track against yourself.
  • Zones from a 20-minute test. The zone bands are set from 2K watts, and no sourced way exists to get 2K watts from a 20-minute result, so that test gives the 60-minute estimate only.
  • Your own zones. The bands are a convention. Heart rate, how you feel, your coach and your recent training should change them.

To plan a race, the Rowing Race Pace Calculator builds the split plan. For critical power and W' from a few maximal efforts, use the Rowing CP Calculator.

To see what a split and stroke rate mean for distance and work per stroke, try the Rowing Stroke Efficiency Calculator. For a rough on-water 2K estimate, use the Erg-to-Boat Speed Calculator.

Frequently Asked Questions

Sources & References

  1. Watts Calculator (pace to watts and watts to pace). Concept2. Concept2.com
  2. Using the indoor rower for testing: why do we test different distances?. World Rowing (interview with Kurt Jensen). worldrowing.com, 26 November 2019 (2019)
  3. Is the FTP test a reliable, reproducible and functional assessment tool in highly-trained athletes?. McGrath E, Mahony N, Fleming N, Donne B. International Journal of Exercise Science 12(4):1334-1345 (2019)
  4. Maximal lactate steady state versus the 20-minute functional threshold power test in well-trained individuals: "Watts" the big deal?. Inglis EC, Iannetta D, Passfield L, Murias JM. International Journal of Sports Physiology and Performance 15(4):541-547 (2020)
  5. Agreement of maximal lactate steady state with critical power and physiological thresholds in rowing. Possamai LT, Borszcz FK, de Aguiar RA, de Lucas RD, Turnes T. European Journal of Sport Science 22(3):371-380 (2022)
  6. Critical concept indexes are not steady-state intensities in indoor rowing exercise (conference abstract). Lin HF, Lin JC, Chuang TY. Medicine & Science in Sports & Exercise 38(Suppl):S488 (2006)
  7. The Training Matrix. GB Rowing Team, British Rowing. plus.britishrowing.org (PDF, uploaded January 2023) (2023)
  8. Maximal lactate steady state rowing intensity can be predicted by a 6-km rowing time trial (conference abstract). Gutilla MJ, Mattern CO, Meissner M, Bouton KD, Kirby TE, Devor ST. Medicine & Science in Sports & Exercise 36(Suppl):S43-S44 (2004)
  9. Training and Racing with a Power Meter, 2nd ed.. Allen H, Coggan AR. VeloPress (book) (2015)
  10. Focus on Watts/strokes per min - pro/con? (forum post quoting the UK interactive plan zone chart; not a primary source). Concept2 Forum users. c2forum.com, thread 13169
  11. ISS Interactive Plan Errors, Inconsistencies, and Oddities (forum post; not a primary source). Concept2 Forum users. c2forum.com, thread 201064
Manish Kumar
Manish Kumar

Certified Personal Trainer & Sports Nutritionist

NASM-CPTCertified Sports Nutritionist10+ Years Experience500+ Clients Coached

NASM-certified fitness and nutrition coach with over 10 years of hands-on experience helping people build strength, lose fat, and live healthier lives. Specializing in gym-based workouts with a strong focus on lifting technique, biomechanics, and practical exercise science. Through FitLifeRegime, sharing the tools, tips, and insights that have worked for hundreds of clients — helping you start your own fitness journey with confidence and clarity.

Learn more about Manish
NASM Certified Personal Trainer Certificate

NASM Certified

Certified Personal Trainer & Sports Nutritionist from the National Academy of Sports Medicine

Disclaimer: This calculator is for informational and personal journaling purposes only. It logs measurements and compares them to published reference values. It is not health, medical, or nutrition advice.