Key Takeaways
- Casey Butt's equations estimate the most lean mass, and the muscle measurements, a drug-free man of your height, wrist and ankle size is likely to reach[1].
- 100% is the equation's ceiling. Butt calls 95% a good lifetime goal for most genetically typical drug-free trainees[1].
- The model is self-published. Butt built it from about 300 class and overall winners he classes as drug-free, and no peer-reviewed paper or underlying data is published[1].
- It was written for men from roughly 5′5″ to 6′2″ with average frames, at about 8 to 12% body fat[1][2]. Outside that, the result is an extrapolation.
- There is no female mode. The model was fitted to men, and no published version exists for women.
What This Calculator Estimates
Three things from your height and two joint sizes.
Casey Butt, who says he holds a Ph.D. in controls engineering[2], fitted equations to the heights, wrist sizes and ankle sizes of about 300 drug-free class and overall winners and strength athletes[1]. The calculator runs those published equations.
Maximum lean body mass
The most muscle and other fat-free tissue the equation predicts at the body fat you pick. It rises a little with body fat, because Butt found heavier athletes carried more lean mass[1].
Maximum bodyweight
The lean mass plus the fat that goes with it at that body fat. A bulked figure adds Butt's allowance of up to 4% for water and food[1].
Maximum measurements
Chest, biceps, forearms, neck, thighs and calves in a lean condition, about 8 to 10% body fat[1].
Wrist and ankle size stand in for the size of your skeleton, which carries little muscle or fat. Frame does matter, but it is not the whole story.
In one study of 224 white American men aged 23 to 65, frame breadths and age together explained about 35% of the variation in height-adjusted fat-free mass[4]. Those were bone breadths, not the circumferences used here.
How to Measure
Three required numbers, plus six optional ones.
Required
- Height. Stand barefoot against a wall and measure to the top of your head.
- Wrist. Wrap the tape around your wrist on the hand side of the styloid process, the bony lump on the outside of the wrist[1]. Keep it snug without squeezing.
- Ankle. Measure at the smallest circumference, just above the ankle bone[1].
- Body fat to plan for. The default of 10% sits inside Butt's range. Skinfold methods can read up to about 4% too low in heavily muscled people[1].
In the lean-mass equation the wrist and ankle sit under a square root, so a small error moves the result less than a height error would. A loose tape or a reading taken over the bone still shifts it.
The six optional measurements are for the comparison. Butt gives these procedures for the maximums[1]. Tape should be snug but not press into the skin.
| Site | How to measure |
|---|---|
| Chest | Relaxed, not expanded, arms at your sides, tape under the armpits. |
| Biceps | Flexed, at the largest point. |
| Forearms | Fist clenched, hand out straight, at the largest point. |
| Neck | Below the Adam’s apple, at the smallest point. |
| Thighs | Standing relaxed, midway between hip and knee. |
| Calves | Standing relaxed, at the largest point. |
Measurement positions for the maximums. Use the same positions for your own numbers.
How the Formulas Work
Butt's published equations, unchanged.
H, W and A are height, wrist and ankle in inches, and BF is body fat in percent. Lean mass comes out in pounds, and the calculator converts your metric entries first.
LBM = H^1.5 x (sqrt(W) / 22.667 + sqrt(A) / 17.0104) x (BF / 224 + 1)
Bodyweight = LBM / (100 - BF) x 100
Bulked bodyweight = Bodyweight x 1.04
Butt gives six equations for the measurements[1]. They use only the inputs shown, so a girth does not change when you change the body fat setting.
| Site | Equation |
|---|---|
| Chest | 1.6817 W + 1.3759 A + 0.3314 H |
| Biceps | 1.2033 W + 0.1236 H |
| Forearms | 0.9626 W + 0.0989 H |
| Neck | 1.1424 W + 0.1236 H |
| Thighs | 1.3868 A + 0.1805 H |
| Calves | 0.9298 A + 0.1210 H |
Maximum measurements in inches, from Butt's published equations.
The 95% tier is Butt's own rule of thumb, applied to all the outputs. It is not a separate equation.
Worked Example
Butt’s own trainee: 5′9″, 7.0″ wrist, 8.7″ ankle, 10% body fat.
Butt uses this man in his article, and the calculator returns the same figures he prints[1].
Height: 69^1.5 = 573.16
Frame: sqrt(7.0) / 22.667 + sqrt(8.7) / 17.0104 = 0.2901
Body fat: 10 / 224 + 1 = 1.0446
Lean mass: 573.16 x 0.2901 x 1.0446
Bodyweight: 173.7 / (100 - 10) x 100
At 95% that is 165 lb of lean mass and 183.4 lb of bodyweight. The bulked figure is 200.7 lb, which matches Butt's article[1].
| Site | 100% (in) | 95% (in) | 100% (cm) |
|---|---|---|---|
| Chest | 46.6 | 44.3 | 118.4 |
| Biceps | 17 | 16.1 | 43.1 |
| Forearms | 13.6 | 12.9 | 34.4 |
| Neck | 16.5 | 15.7 | 42 |
| Thighs | 24.5 | 23.3 | 62.3 |
| Calves | 16.4 | 15.6 | 41.8 |
Maximum measurements for the same trainee. Butt's article prints the first column rounded to the same tenth.
Reading Your Result
What 100% and 95% each mean, and when you can pass them.
100% is the ceiling
It scales your frame to the build of drug-free champions from 1947 to 2010[1]. He says it takes years of dedicated training for most genetically typical trainees to even approach it, and that most people will never match it in every muscle group.
95% is the goal Butt suggests
He calls it a good lifetime goal for most genetically typical drug-free trainees. In his words, reaching 95% of most of the predictions in lean condition would make you stand out in almost any gym[1].
Passing 100% is possible
For lean mass, Butt allows up to roughly 5% more in extreme cases, such as wide hips and thick shoulders, high natural testosterone, very long muscle bellies or unusually small joints[1]. For a single girth he allows about 3%. Very thin ectomorphs may reach only about 95% of the lean mass figure.
Measure lean for the girths
The girths describe a lean condition. Butt says that if you reach them yet still do not look impressive, you are probably too fat[1].
Guidelines, not limits
Butt writes that the numbers are meant as maximum guidelines and are not limitations[1]. If a body part is far below its figure, you probably have room to grow.
Casey Butt Versus FFMI
Two ways to put a ceiling on muscle, built on different inputs.
Fat-free mass index (FFMI) is fat-free mass in kilograms divided by height in metres squared. Kouri and colleagues added a correction to scale everyone to 1.80 m[3].
In their 157 male athletes, the 74 who had not used steroids reached up to 25.0 on this scale. Twenty Mr. America winners from 1939 to 1959 averaged 25.4. The authors call these findings preliminary.
Butt says an FFMI ceiling ignores bone structure, and he compared his fits with the FFMI of champion bodybuilders from Kouri's work[1]. So the two methods can disagree. The sample man above comes out at an FFMI of 26.0 at his maximum, a little above both of Kouri's figures.
Using the two together
FFMI is a handy check on where you are now, and Butt's figure works as a rough target. Kouri's 25.0 comes from one 1995 sample, so treat it as a reference point, not a rule. When the two differ, neither is a measured limit.
Limits of This Tool
Read the output as an estimate from one self-published model.
Self-published, data not public
No peer-reviewed paper or dataset is published for the equations. Butt names some historical champions in his tables, leaves the current ones unnamed at their request, and decides himself who counts as drug-free[1].
His check table lists predicted weights that match actual weights almost to the pound, and its body fat column is labelled “predicted”. That reads as an illustration, not an independent test[1].
Built from elite men
The sample is class and overall winners. The ceiling it gives suits people with champion-level genetics, and Butt says most trainees will not quite reach it[1].
Men only, so no female mode
The equations were fitted to male data, and no sourced factors exist to scale them for women.
Average frames and heights
Butt says the equations suit roughly 5′5″ to 6′2″ and average bone structure. A thin wrist with broad shoulders, or the reverse, makes the estimate less reliable[1].
Body fat range and error
The free formulas may run high
Menno Henselmans says calculators built on Butt's free equations give higher estimates than his own method, because that research used a smaller sample of almost exclusively top-tier genetics[5]. That is his view, not a tested result.
He also says a later edition of Butt's book uses a larger sample and different formulas[5]. This calculator runs only the equations in the free article, so it may not match the book.
Frequently Asked Questions
Sources & References
- Your Maximum Muscular Bodyweight and Measurements. Butt C. WeighTrainer article. The equations, the 95% goal, the 5% and 3% allowances, the applicable heights and the measurement positions. The article gives the end year of the sample as 2010 in one place and 2007 in another. Read on 4 November 2026.
- An Interview with Casey Butt, Part 1. Muscle & Strength. Interview. Source for the 8 to 12% body fat range and for Butt's credentials as he states them. Read on 4 November 2026.
- Fat-free mass index in users and nonusers of anabolic-androgenic steroids. Kouri EM, Pope HG Jr, Katz DL, Oliva P. Clinical Journal of Sport Medicine 5(4):223-228 (1995)
- Relations between frame size and body composition and bone mineral status. Chumlea WC, Wisemandle W, Guo SS, Siervogel RM. American Journal of Clinical Nutrition 75(6):1012-1016 (2002)
- FFMI Calculator: Calculate your genetic muscular potential. Henselmans M. Third-party calculator page. Source for his view that calculators built on Butt's free equations run higher than his own method, and for his statement that a later edition of Butt's book uses a larger sample. Read on 4 November 2026.

Certified Personal Trainer & Sports Nutritionist
NASM-certified fitness and nutrition coach with over 10 years of hands-on experience helping people build strength, lose fat, and live healthier lives. Specializing in gym-based workouts with a strong focus on lifting technique, biomechanics, and practical exercise science. Through FitLifeRegime, sharing the tools, tips, and insights that have worked for hundreds of clients — helping you start your own fitness journey with confidence and clarity.
Learn more about Manish
NASM Certified
Certified Personal Trainer & Sports Nutritionist from the National Academy of Sports Medicine
Disclaimer: This calculator runs a self-published set of equations and shows an estimate of an upper limit for a drug-free man. It does not measure your muscle, predict your results or tell you how to train. Individual limits vary. If you have a health condition or an eating disorder history, talk to a clinician before using body targets to guide your diet or training.